TM 10-3930-675-20-1
0007 00-50
ENGINE FUEL INJECTOR CIRCUITS TROUBLESHOOTING - CONTINUED
0007 00
Table 10. Error Code 1325 - Injector Circuit Failure Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1325 - Injector Circuit Failure -
Continued
b. Check internal actuator
harness
and
injector
solenoid connector for dirt
or moisture in or on
connector and for missing
or
damaged
connector
seals.
Remove dirt and moisture from
connector. Replace missing or
damaged connector seals (WP
0111 00).
7. Place ignition switch in OFF
position and, with rocker arm
cover removed, disconnect
actuator harness from 15-pin
connector
and
injector
solenoid wires from no. 6
injector solenoid.
a. Measure resistance from
15-pin connector pin 1 (or
A) to each injector pigtail
nut that connects the No. 1
injector (resistance to one
of these nuts must be within
specifications). Resistance
should be less than 10
ohms.
a. If resistance is not as
specified, repair or replace
connectors (WP 0111 00).
b. If internal actuator harness
requires replacement, notify
SRA.
b. Measure resistance from
15-pin connector pin 2 (or
B) to each injector pigtail
nut that connects the No. 1
injector (resistance to one
of these nuts must be within
specifications). Resistance
should be less than 10
ohms.
If resistance is not as specified,
notify SRA to replace internal
actuator harness.