TM 10-3930-675-20-1
0007 00-47
ENGINE FUEL INJECTOR CIRCUITS TROUBLESHOOTING - CONTINUED
0007 00
Table 10. Error Code 1325 - Injector Circuit Failure Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1325 - Injector Circuit Failure -
Continued
4. Place ignition switch to OFF
position
and
disconnect
actuator harness from engine
ECU and 15-pin connector at
front of engine below rocker
arm cover. Disconnect sensor
harness from engine ECU.
a. Measure resistance from
actuator harness connector
pin 1 to all pins in actuator
harness
connector.
Resistance
should
be
greater than 100k ohms.
a. If resistance is not as
specified, repair or replace
connectors (WP 0111 00).
b. If engine harness requires
replacement, notify SRA.
b. Measure resistance from
actuator harness connector
pin 1 to all pins in sensor
harness
connector.
Resistance
should
be
greater than 100k ohms.
a. If resistance is not as
specified, repair or replace
connectors (WP 0111 00).
b. If engine harness requires
replacement, notify SRA.
<10 OHMS
