Error Code 1325 - Injector Circuit Failure - Continued

Error Code 1325 - Injector Circuit Failure - Continued - TM-10-3930-675-20-1_166

Error Code 1325 - Injector Circuit Failure - Continued - TM-10-3930-675-20-1_168

TM-10-3930-675-20-1 Rough Terrain Container Handler (RTCH): RT 240; 53 000 Lb Capacity; 4x4 Manual
Page Navigation
140

TM 10-3930-675-20-1 0007 00-49 ENGINE FUEL INJECTOR CIRCUITS TROUBLESHOOTING - CONTINUED 0007 00 Table 10. Error Code 1325 - Injector Circuit Failure Troubleshooting Procedures - Continued. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error Code 1325 - Injector Circuit Failure - Continued a. Measure resistance from actuator harness connector pin 1 to engine block ground. Resistance should be greater than 100k ohms. a. If resistance is not as specified, repair or replace connectors (WP 0111 00). b. If engine harness requires replacement, notify SRA. b. Measure resistance from actuator harness connector pin 2 to engine block ground. Resistance should be greater than 100k ohms. a. If resistance is not as specified, repair or replace connectors (WP 0111 00). b. If engine harness requires replacement, notify SRA. 6. Place ignition switch to OFF position. Remove rocker arm cover (WP 0051 00). Disconnect injector solenoid connector from no. 6 injector solenoid and internal actuator harness from 15-pin connector. a. Inspect internal actuator harness and injector solenoid connector for dirty, corroded, bent, broken, pushed back, and extended pins. Clean and repair connector(s) as required (WP 0111 00). >100K OHMS

Privacy Statement
Press Release
Contact