ENGINE TPS AND IDLE VALIDATION SWITCH TROUBLESHOOTING

Table 1. Error Code 1131 - Throttle Position Sensor Circuit Failure Troubleshooting Procedures - Cont

TM-10-3930-675-20-1 Rough Terrain Container Handler (RTCH): RT 240; 53 000 Lb Capacity; 4x4 Manual
Page Navigation
165

TM 10-3930-675-20-1 0008 00-1 ENGINE TPS AND IDLE VALIDATION SWITCH TROUBLESHOOTING 0008 00 THIS WORK PACKAGE COVERS Error Code 1131 - Throttle Position Sensor Circuit Fail- ure Error Code 1132 - Throttle Position Sensor Circuit Fail- ure Error Code 1431 - 1dle Validation Switch Circuit Fail- ure Error Code 1432 - Accelerator Pedal Circuit Failure Error Code 1551 - Idle Validation Switch Circuit Fail- ure INITIAL SETUP References TM 10-3930-675-10 Tools and Special Tools Test lead, female (Item 48, WP 0204 00) Test lead, female (Item 49, WP 0204 00) Test lead, female (Item 50, WP 0204 00) Test lead, male (Item 51, WP 0204 00) NOTE Refer to WP 0004 00 for additional troubleshooting guidance, information, and illustrations that locate criti- cal components. Table 1. Error Code 1131 - Throttle Position Sensor Circuit Failure Troubleshooting Procedures. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error Code 1131 - Throttle Position Sensor Circuit Failure 1. Place ignition switch to OFF position and disconnect harness from throttle position sensor. a. Inspect harness connector and throttle position sensor connector for dirty, corroded, bent, broken, pushed back, and extended pins. Clean and repair connector(s) as required (WP 0111 00). b. Check harness and throttle position sensor for dirt or moisture in or on connector and for missing or damaged connector seals. Remove dirt and moisture from connector. Replace missing or damaged connector seals (WP 0111 00).

Privacy Statement
Press Release
Contact