Error Code 1432 - Accelerator Pedal Circuit Failure - Continued

Table 4. Error Code 1432 - Accelerator Pedal Circuit Failure Troubleshooting Procedures

Error Code 1432 - Accelerator Pedal Circuit Failure - Continued - TM-10-3930-675-20-1_216

TM-10-3930-675-20-1 Rough Terrain Container Handler (RTCH): RT 240; 53 000 Lb Capacity; 4x4 Manual
Page Navigation
187

TM 10-3930-675-20-1 0008 00-23 ENGINE TPS AND IDLE VALIDATION SWITCH TROUBLESHOOTING - CONTINUED 0008 00 Table 4. Error Code 1432 - Accelerator Pedal Circuit Failure Troubleshooting Procedures. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error Code 1432 - Accelerator Pedal Circuit Failure - Continued b. Measure resistance from harness connector pin 47 to pin 48 with accelerator pedal in depressed position. Resistance should be 250- 1500 ohms. If harness requires replacement, notify SRA. 3. Place ignition switch in OFF position, disconnect harness from throttle position sensor, and disconnect OEM harness connector from engine ECU. a. Measure resistance from harness connector pin 5 to pin 6 on 690 connector (X690) of throttle position sensor, with accelerator pedal in released position. Resistance should be 1500- 3000 ohms. If harness requires replacement, notify SRA. b. Repeat above measurement with accelerator pedal in depressed position. Resistance should be 250- 1500 ohms. If harness requires replacement, notify SRA. 5,6 USE TEST LEAD KIT P/N 3822917 1500-3000 OHMS RELEASED 250-1500 OHMS DEPRESSED NOTE: RELEASED VALUE MUST BE AT LEAST 1000 OHMS GREATER THAN DEPRESSED VALUE X690 1 OR 2 GN 3 BU BK 6 RD 5 WH 4

Privacy Statement
Press Release
Contact