Error Code 1434 - Unswitched Battery Supply Circuit Failure - Cont

Error Code 1434 - Unswitched Battery Supply Circuit Failure - Cont - TM-10-3930-675-20-1_423

Error Code 1434 - Unswitched Battery Supply Circuit Failure - Cont - TM-10-3930-675-20-1_425

TM-10-3930-675-20-1 Rough Terrain Container Handler (RTCH): RT 240; 53 000 Lb Capacity; 4x4 Manual
Page Navigation
387

TM 10-3930-675-20-1 0025 00-4 ENGINE BATTERY VOLTAGE CIRCUITS TROUBLESHOOTING - CONTINUED 0025 00 Table 1. Error Code 1434 - Unswitched Battery Supply Circuit Failure Troubleshooting Procedures - Continued. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error Code 1434 - Unswitched Battery Supply Circuit Failure - Continued 5. Ensure that ignition switch is in OFF position and disconnect OEM harness connector from engine ECU (794). a. Inspect harness and engine ECU (794) connectors for dirty, corroded, bent, broken, and pushed back or extended pins. Clean and repair connector(s) as required (WP 0111 00). b. Check harness and engine ECU (794) for dirt or moisture in or on connectors and for missing or damaged connector seals. Remove dirt and moisture from connector. Replace missing or damaged connector seals (WP 0111 00). 6. Place ignition in OFF position and disconnect OEM harness connector from engine ECU (794). Perform the following voltage checks. If voltage is not as specified, notify SRA to repair or replace engine harness. a. Measure voltage from OEM harness connector pin 7 to pin 29. Voltage should be 24-30V. b. Measure voltage from OEM harness connector pin 8 to pin 30. Voltage should be 24-30V.

Privacy Statement
Press Release
Contact