Error Code 1441 - Unswitched Battery Supply Circuit Failure - Cont

Error Code 1441 - Unswitched Battery Supply Circuit Failure - Cont - TM-10-3930-675-20-1_428

Error Code 1441 - Unswitched Battery Supply Circuit Failure - Cont - TM-10-3930-675-20-1_430

TM-10-3930-675-20-1 Rough Terrain Container Handler (RTCH): RT 240; 53 000 Lb Capacity; 4x4 Manual
Page Navigation
392

TM 10-3930-675-20-1 0025 00-9 ENGINE BATTERY VOLTAGE CIRCUITS TROUBLESHOOTING - CONTINUED 0025 00 Table 2. Error Code 1441 - Unswitched Battery Supply Circuit Failure Troubleshooting Procedures - Continued. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error Code 1441 - Unswitched Battery Supply Circuit Failure - Continued e. Measure resistance from OEM harness connector pin 28 to positive (+) battery terminal. Resistance should be less than 10 ohms. 6. Place ignition switch in OFF position, disconnect OEM harness connector from engine ECU (794), and disconnect positive (+) terminal from battery. Perform the following resistance checks. Resistance should be greater than 100k ohms. If resistance is not as specified, notify SRA to repair or replace engine harness. a. Measure resistance from OEM harness connector pin 7 to all other pins in connector except pins 8, 17, 18, and 28. b. Measure resistance from OEM harness connector pin 8 to all other pins in connector except pins 7, 17, 18, and 28. c. Measure resistance from OEM harness connector pin 17 to all other pins in connector except pins 7, 8, 18, and 28. d. Measure resistance from OEM harness connector pin 18 to all other pins in connector except pins 7, 8, 17, and 28.

Privacy Statement
Press Release
Contact