Error Code 1474 - Starter Solenoid Lockout Relay Driver Circuit Failure - Cont

Table 4. Error Code 1474 - Starter Solenoid Lockout Relay Driver Circuit Failure Troubleshooting Procedures

Error Code 1474 - Starter Solenoid Lockout Relay Driver Circuit Failure - Cont - TM-10-3930-675-20-1_434

TM-10-3930-675-20-1 Rough Terrain Container Handler (RTCH): RT 240; 53 000 Lb Capacity; 4x4 Manual
Page Navigation
396

TM 10-3930-675-20-1 0025 00-13 ENGINE BATTERY VOLTAGE CIRCUITS TROUBLESHOOTING - CONTINUED 0025 00 Table 4. Error Code 1474 - Starter Solenoid Lockout Relay Driver Circuit Failure Troubleshooting Procedures - Continued. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error Code 1474 - Starter Solenoid Lockout Relay Driver Circuit Failure - Continued 3. Remove XK12 connector from relay board. Check resistance between XK12 connector pin 5 and X16 pin 1. Resistance should be less than 10 ohms. If resistance is not as specified, notify SRA. 4. Disconnect 31-pin harness connector on left side of engine to rear of engine ECU. Measure resistance from pin 20 of 31-pin connector to X16 pin 1. Resistance should be less than 10 ohms. If resistance is not as specified, notify SRA. 5. Ensure that ignition switch is in OFF position. Disconnect actuator harness connector from engine ECU (794). a. Inspect actuator harness and engine ECU connectors for dirty, corroded, bent, broken, and pushed back or extended pins. Clean and repair connector(s) as required (WP 0111 00). b. Check actuator harness and engine ECU for dirt or moisture in or on the connectors and for missing or damaged connector seals. Remove dirt and moisture from connector. Replace missing or damaged connector seals (WP 0111 00). 6. Place ignition switch in OFF position, disconnect actuator harness from 31-pin connector, and disconnect actuator harness connector from engine ECU (794).

Privacy Statement
Press Release
Contact