TM 10-3930-675-20-1
0025 00-17
ENGINE BATTERY VOLTAGE CIRCUITS TROUBLESHOOTING - CONTINUED
0025 00
Table 4. Error Code 1474 - Starter Solenoid Lockout Relay Driver Circuit Failure
Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1474 - Starter Solenoid Lockout
Relay Driver Circuit Failure - Continued
13.Measure resistance from pin
20 on harness side of 31-pin
connector to engine block
ground. Resistance should be
greater than 100k ohms.
If resistance is not as specified,
notify SRA to repair or replace
engine harness.
Table 5. Error Code 1596 - Voltage Monitor, High Voltage Failure Troubleshooting Procedures.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1596 - Voltage Monitor, High
Voltage Failure
1. Check battery and alternator
cable connections for loose
connections and corrosion.
Tighten battery connections and
clean
battery
terminals
as
required.
2. Turn ignition switch to OFF
position and measure battery
voltage from positive (+)
terminal to negative (-)
terminal. Voltage should be at
least 12V. Check each battery
in system
If voltage is not as required,
charge or replace battery (WP
0107 00).
>100K OHMS
USE TEST LEAD KIT P/N 3822758
