Error Code 1474 - Starter Solenoid Lockout Relay Driver Circuit Failure - Cont

Error Code 1474 - Starter Solenoid Lockout Relay Driver Circuit Failure - Cont - TM-10-3930-675-20-1_434

Error Code 1474 - Starter Solenoid Lockout Relay Driver Circuit Failure - Cont - TM-10-3930-675-20-1_436

TM-10-3930-675-20-1 Rough Terrain Container Handler (RTCH): RT 240; 53 000 Lb Capacity; 4x4 Manual
Page Navigation
398

TM 10-3930-675-20-1 0025 00-15 ENGINE BATTERY VOLTAGE CIRCUITS TROUBLESHOOTING - CONTINUED 0025 00 Table 4. Error Code 1474 - Starter Solenoid Lockout Relay Driver Circuit Failure Troubleshooting Procedures - Continued. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error Code 1474 - Starter Solenoid Lockout Relay Driver Circuit Failure - Continued 9. Ensure that ignition switch is in OFF position. Disconnect actuator harness connector from 31-pin connector. a. Inspect actuator harness and 31-pin connectors for dirty, corroded, bent, broken, and pushed back or extended pins. Clean and repair connector(s) as required (WP 0111 00). b. Check actuator harness and 31-pin connector for dirt or moisture in or on connectors and for missing or damaged connector seals. Remove dirt and moisture from connector. Replace missing or damaged connector seals (WP 0111 00). >100K OHMS USE TEST LEAD KIT P/N 3822758

Privacy Statement
Press Release
Contact