Error Code 1474 - Starter Solenoid Lockout Relay Driver Circuit Failure - Cont

Error Code 1474 - Starter Solenoid Lockout Relay Driver Circuit Failure - Cont - TM-10-3930-675-20-1_435

Error Code 1474 - Starter Solenoid Lockout Relay Driver Circuit Failure - Cont - TM-10-3930-675-20-1_437

TM-10-3930-675-20-1 Rough Terrain Container Handler (RTCH): RT 240; 53 000 Lb Capacity; 4x4 Manual
Page Navigation
399

TM 10-3930-675-20-1 0025 00-16 ENGINE BATTERY VOLTAGE CIRCUITS TROUBLESHOOTING - CONTINUED 0025 00 Table 4. Error Code 1474 - Starter Solenoid Lockout Relay Driver Circuit Failure Troubleshooting Procedures - Continued. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error Code 1474 - Starter Solenoid Lockout Relay Driver Circuit Failure - Continued 10.Ensure that ignition switch is in OFF position. Disconnect actuator harness connector from 31-pin connector and disconnect XK12 connector from relay board. 11.Measure resistance from pin 20 on harness side of 31-pin connector to all other pins in connector. Resistance should be greater than 100k ohms. If resistance is not as specified, notify SRA to repair or replace engine harness. 12.Ensure that ignition switch is in OFF position. Disconnect actuator harness connector from 31-pin connector and disconnect XK12 connector from relay board. >100K OHMS USE TEST LEAD KIT P/N 3822758

Privacy Statement
Press Release
Contact