Table 5. Error Code 1596 - Voltage Monitor, High Voltage Failure Troubleshooting Procedures

Error Code 1474 - Starter Solenoid Lockout Relay Driver Circuit Failure - Cont - TM-10-3930-675-20-1_437

Error Code 1596 - Voltage Monitor, High Voltage Failure - Cont

TM-10-3930-675-20-1 Rough Terrain Container Handler (RTCH): RT 240; 53 000 Lb Capacity; 4x4 Manual
Page Navigation
401

TM 10-3930-675-20-1 0025 00-18 ENGINE BATTERY VOLTAGE CIRCUITS TROUBLESHOOTING - CONTINUED 0025 00 Table 5. Error Code 1596 - Voltage Monitor, High Voltage Failure Troubleshooting Procedures. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error Code 1596 - Voltage Monitor, High Voltage Failure - Continued 3. Turn ignition switch to OFF position and measure battery voltage from positive (+) terminal to negative (-) terminal. Voltage should be +12V. Check voltage while trying to start engine. Voltage should be at least +6V during cranking. Check each battery in system. If voltage is not as required, charge or replace battery (WP 0107 00). 4. Place ignition switch in OFF position and install ammeter between alternator and battery. Perform the following to check charging rate of alternator. If alternator is not charging properly, replace alternator (WP 0069 00). a. Check battery voltage at slave receptacle with engine off. b. Start engine and recheck voltage. Voltage should be slightly higher than voltage checked with engine off. c. Turn on lights. Check amperage reading on ammeter with engine on. Ammeter should have a positive (more or less) reading depending on charge of batteries. +12V = STATIC +6V = START

Privacy Statement
Press Release
Contact