TM 10-3930-675-20-20078 00-3ENGINE ELECTRONIC CONTROL MODULE (ECM) REPLACEMENT - CONTINUED0078 00INSTALLATION - CONTINUED3.Position actuator harness connector (6), sensor harness connector (8), and 32-pin connector (12) with bracket (10).4.Install screw (9) and washer (3) to secure bracket (10) to ECM (5). Tighten captive screws (13) to 25 lb-in (3 Nm) tosecure connectors.5.Position engine wiring harness (14) and OEM wiring harness. Secure engine wiring harness with cable clamp (1), screw(2), and washer (3). Tighten captive screw (13) on OEM wiring harness to 25 lb-in (3 Nm).6.Connect wiring harness (11) to 32-pin connector (12).7.Fully tighten ECM screws (2 and 9) evenly to 180 lb-in (20 Nm).NOTEIf ECM is new, it must be calibrated with information saved from old ECM.8.Calibrate ECM, if required.9.Install engine cover (WP 0143 00).END OF WORK PACKAGE
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
