TM 10-3930-675-20-2
0093 00-3
ENGINE SENSORS REPLACEMENT - CONTINUED
0093 00
ENGINE POSITION SENSOR REMOVAL
1.
Disconnect connector (9) of engine position sensor (8) from connector (10) of engine wiring harness.
2.
Remove engine position sensor (8) and o-ring seal (7) from engine front cover (6). Discard o-ring seal.
ENGINE POSITION SENSOR INSTALLATION
NOTE
Ensure sensor is free of debris and is not chipped, cracked or damaged.
1.
Install new o-ring seal (7) on engine position sensor (8).
2.
Install engine position sensor (8) on engine front cover (6). Tighten sensor to 216 lb-in (24 Nm).
NOTE
Ensure locking tab on connector snaps in place.
3.
Connect engine wiring harness connector (10) to connector (9) of engine position sensor (8).
4.
Install engine cover (WP 0143 00).
6
7
8
9
10