TM 10-3930-675-20-2
0093 00-4
ENGINE SENSORS REPLACEMENT - CONTINUED
0093 00
INTAKE AIR TEMPERATURE SENSOR REMOVAL
1.
Disconnect connector (11) of engine wiring harness (2) from intake air temperature sensor (12).
2.
Remove intake air temperature sensor (12) and o-ring seal (13) from intake manifold (14). Discard o-ring seal.
INTAKE AIR TEMPERATURE SENSOR INSTALLATION
1.
Install new o-ring seal (13) on intake air temperature sensor (12).
2.
Install intake air temperature sensor (12) on intake manifold (14). Tighten sensor to 120 lb-in (14 Nm).
NOTE
Ensure locking tab on connector snaps in place.
3.
Connect connector (11) of engine wiring harness (2) to intake air temperature sensor (12).
4.
Install engine cover (WP 0143 00).
INTAKE MANIFOLD PRESSURE SENSOR REMOVAL
1.
Disconnect connector (15) of engine wiring harness (2) from intake manifold pressure sensor (17).
NOTE
Ensure a 1-¼ in deep well socket is used for removal and installation of intake manifold pressure sensor.
2.
Remove intake manifold pressure sensor (17) and o-ring seal (16) from intake manifold (14). Discard o-ring seal.
2
11
12
13
14
