TM 10-3930-675-20-2
0140 00-6
TOPHANDLER WEAR PLATES REPLACEMENT - CONTINUED
0140 00
STYLE B WEAR PLATE REMOVAL
NOTE
Style B wear plates use the same hardware. For removal procedures, refer to step 1 below.
Access procedures and requirements for each location are different. Refer to steps 2 and 3 for specific
access procedures.
1.
To remove a style B wear plate mounted on sideshift carriage frame, perform the following:
a.
Remove four screws (10) and washers (11) securing mounting plate (12), backing plate (13), and frame (15) to
sideshift carriage frame (9).
b.
Remove screw (7) and washer (8) securing wear plate (14).
c.
Remove spacer (12), spacer (13), frame (15), and wear plate (14).
d.
Measure thickness of wear plate (14). Measurement to be not less than 0.5 in (13 mm).
e.
If measurement is more than 0.5 in (12.7 mm) but less than 1 in (25.4 mm), add backing plates (13) as needed.
7,8
10,11
10,11
12,13
14,15
9