TM 10-3930-675-20-2
0140 00-12
TOPHANDLER WEAR PLATES REPLACEMENT - CONTINUED
0140 00
STYLE D WEAR PLATE REMOVAL
NOTE
•
If measurement of wear plate is less 0.5 in (12.7 mm), perform steps below to replace wear plate.
•
Note location of beveled edge on wear plate. Ensure wear plate is oriented with beveled edge in same
position for installation.
1.
Position sliding beam to access wear plate (31) and remove two screws (36) and lock plate (33).
2.
Thru access hole in extending beam, remove two screws (34) and washers (35) securing wear plate (31) and shims (32).
3.
Slide two wear plates (31) and shims (32) from extending beam location.
STYLE D WEAR PLATE INSTALLATION
NOTE
Ensure wear plates are oriented with beveled edge the same as noted in removal.
1.
Position two wear plates (31) on extending beam.
2.
Install two screws (34) and washers (35) thru access hole in extending beam to secure wear plates (31).
3.
Position lock plate (33) on extending beam.
4.
Install two screws (36) to secure lock plate (33).
5.
Tighten all screws in accordance with Torque Limits (WP 0198 00).
6.
Perform operational check of tophandler (TM-10-3930-675-10).
STYLE E WEAR PLATE REMOVAL
NOTE
If measurement of wear plate is less 0.5 in (12.7 mm), perform steps below to replace wear plate.
31
32
33
31
32
34,35
36
