TM 10-3930-675-20-2
0168 00-2
CAB TRANSPORT CONTROL VALVE REPLACEMENT - CONTINUED
0168 00
REMOVAL
1.
Disconnect nine hoses (1) from fittings at control valve (9).
2.
Remove four screws (5), nuts (6), washers (7), and control valve (9) from remote hydraulic control compartment.
NOTE
Perform step 3 to remove fittings from control valve, if a new control valve is being installed.
3.
Remove elbow (3), tee (2), adapter fittings (4), and nipples (8) from control valve (9).
INSTALLATION
NOTE
•
Refer to General Maintenance Instructions (WP 0194 00) for complete instructions on connecting
hydraulic hoses and applying proper torque.
•
Perform step 1 to install fittings removed from old control valve, if a new control valve is being
installed.
1.
Install nipples (8), adapter fittings (4), elbow (3), and tee (2) to control valve (9).
2.
Install control valve (9) to remote hydraulic control compartment with four screws (5), nuts (6), and washers (7).
3.
Connect nine hoses (1) to fittings at control valve (9).
4.
Check oil level in hydraulic reservoir (LO 10-3930-675-12).
5.
Start engine (TM 10-3930-675-10), operate control valve levers, and check for leaks.
6.
Install new tiedown straps as necessary to support hydraulic hoses.
NOTE
Replace hydraulic reservoir return filters after 100 hours of operation (WP 0183 00).
END OF WORK PACKAGE
9
1
2
3
4
5,6,7
8
1
