TM 10-3930-675-24-1
ENGINE TPS AND IDLE VALIDATION SWITCH TROUBLESHOOTING - CONTINUED
0009 00
Table 1. Error Code 1131 - High Voltage Detected at Throttle Position
Sensor Circuit Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1131 - Throttle Position Sensor 3. Inspect connector X23 for a. If resistance is not as specified,
Circuit - Continued.
damage. Check resistance on
continue with step 4.
the loose part of connector X23 b. Repair or replace damaged
between pins 4 and 5.
connector (WP 0113 00).
Resistance should be 2,000 to
3,000 Ohms (WP 0048 00-11).
4. Check resistance on the loose If resistance is not as specified,
part of connector X23 between continue with step 5.
pins 3 and 4. Resistance should
be 1,500 to 3,000 Ohms with
the pedal released and 250 to
1,500 Ohms with the pedal
depressed (WP 0048 00-11).
5. Check connector. Remove the
kick panel from in front of the
steering column to access the
X690 connector on the
accelerator
pedal
wiring
harness.
6. Check
for
Disconnect X690 and inspect
for damage. Check resistance
on the accelerator pedal part of
connector X690 between pins
4 and 5. Check each pin for
continuity
to
ground.
Resistance should be 2,000 to
3,000 Ohms and there should
be no continuity to ground
(WP 0048 00-11).
0009 00-2
