TM 10-3930-675-24-1
ENGINE TPS AND IDLE VALIDATION SWITCH TROUBLESHOOTING - CONTINUED
0009 00
Table 1. Error Code 1131 - High Voltage Detected at Throttle Position Sensor Circuit
Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1131 - High Voltage Detected at
Throttle Position Sensor Circuit - Continued.
9. Check resistance at the OEM If resistance is not as specified,
harness connector between proceed with step 10.
pins 48 and 49. Resistance
should be 2,000 to 3,000 Ohms
(WP 0048 00-11).
10.Check resistance at the OEM If resistance is not as specified,
harness connector between proceed with step 11.
pins 47 and 48. Resistance
should be 1,500 to 3,000 Ohms
with the pedal released and 250
to 1,500 Ohms with the pedal
depressed (WP 0048 00-11).
>1500-3000 OHMS
RELEASED
250-1500 Ohms
DEPRESSED
USE TEST LEAD KIT P/N 3822758
11.Check
for
continuity.
If continuity to ground is found at
Disconnect connector X16 and
any one wire or any wire is found
the OEM harness connector.
to be open, replace engine and
Check continuity and for
transmission wiring harness (WP
continuity to ground for wires
0113 00).
163, 164, and 165 (WP 0048
00-11).
0009 00-6
