TM 10-3930-675-24-2
MAIN HYDRAULIC SYSTEM HOSES AND FITTINGS REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Materials/Parts - Continued
Maintenance Level
Organizational
Nut, lock (as required)
O-ring (as required)
Tools and Special Tools
Tool Kit, General Mechanic's (Item 128, WP 0289
References
Pan, Drain (Item 76, WP 0289 00)
Materials/Parts
Cap Set, Protective (Item 5, WP 0290 00)
Oil, Lubricating, OE/HDO 10 (Item 26, WP 0290
Equipment Condition
Wheels chocked
Rag, Wiping (Item 30, WP 0290 00)
Parking brake applied (TM 10-3930-675-10)
Strap, Tiedown (Item 37, WP 0290 00)
Hydraulic system pressure relieved (WP 0164 00)
Tag, Marker (Item 38, WP 0290 00)
WARNING
DO NOT disconnect or remove any hydraulic system line or fitting unless hydraulic system pres-
sure has been relieved. Tighten all connections before applying pressure. Escaping hydraulic fluid
under pressure can penetrate the skin, causing serious injury.
Search for leaks with a piece of cardboard. Protect hands and body from high-pressure fluids. If
an accident occurs, see a doctor immediately. Any fluid injected into the skin must be surgically
removed within a few hours or gangrene may result.
At operating temperature, hydraulic oil is hot. Allow hydraulic oil to cool before disconnecting
any hydraulic lines. Failure to do so could result in injury.
Hydraulic fluid is very slippery. Immediately wipe up any spills. Failure to follow this warning
may result in injury to personnel.
CAUTION
Wipe area clean around all hydraulic connections prior to disconnecting. Cap or plug all open-
ings after disconnecting. Contamination of hydraulic system could result in equipment failure.
If replacing hydraulic line coming from bottom of reservoir, close ball valve at reservoir so reser-
voir need not be drained. After installation of hydraulic line, be sure to open ball valve to restore
hydraulic fluid flow. Failure to do so will damage equipment.
NOTE
Tag all hydraulic lines.
