TM 10-3930-675-24-2
CYLINDER HEAD REPAIR - CONTINUED
0200 00
DISASSEMBLY - CONTINUED
NOTE
If injector sleeve is defective, remove in the following manner. Any damaged or defective injector
sleeve is removed in the same manner.
9.
Install injector sleeve puller tool (15). Remove injector sleeve (16) and O-ring (17). Discard O-ring.
15
16
17
CLEANING
WARNING
When using steam cleaner, wear protective clothing and eye protection. Hot steam will cause seri-
ous burns.
Compressed air used for cleaning or drying purposes, or for clearing restrictions, should never
exceed 30 psi (207 kPa). Use protective equipment and exercise caution to avoid injury to person-
nel.
1.
Steam clean cylinder head and dry with compressed air.
2.
Remove all gasket deposits from rocker lever housing surface. Use Abrasive Pad (Item 1, WP 0290 00) to clean com-
bustion face and exhaust gasket surface.
3.
Clean fuel and oil passages with cleaning brush to remove deposits and obstructions.
0200 00-5