TM 10-3930-675-24-2
ROCKER ARM ASSEMBLY MAINTENANCE - CONTINUED
0206 00
INSTALLATION - CONTINUED
f.
Insert 0.020 in. (0.50 mm) feeler gage between number two support (6) and intake lever for number one cylinder.
g.
Push or tap number one support (7) toward rear of engine.
h.
Fully tighten four support mounting screws (8) to 135 lb-ft (183 Nm).
0.50 MM
(0.020 IN.)
INTAKE
6
LEVER
7
REAR OF ENGINE
8
8
NOTE
Injector push rods are smaller in diameter and longer than valve push tubes.
4.
Apply a light coat of clean lubricating oil to ball end of push rods (3) and push tubes (2).
NOTE
Ensure push rods and tubes are installed in position as noted in removal.
5.
Install valve push tubes (2) and injector push rods (3) and tighten adjusting screws (1) enough to hold push rods and
tubes in position.
1
2
3
2
0206 00-11
