TM 10-3930-675-24-2
INTAKE MANIFOLD REPLACEMENT - CONTINUED
0211 00
INSTALLATION
NOTE
Ensure intake manifold and rocker arm housing mating surfaces have been cleaned and all old gasket
material removed.
1.
Position new gasket (3) and intake manifold (1).
2.
Secure intake manifold (1) with 24 screws (2).
2
1
ROCKER ARM
HOUSING
3
3.
Tighten screws (2) in sequence shown to 35 lb-ft (47 Nm).
6 10
18 14 11 7
3
2
13
17
20
22
21
24
23
19
8
4
12
1
15
5
9
16
TIGHTENING SEQUENCE
4.
Install engine sensors on intake manifold (WP 0094 00).
5.
Install air ducts (WP 0058 00).
6.
Start engine (TM 10-3930-675-10). Operate engine at high idle and use a solution of soapy water to check for air leaks.
7.
Install engine cover (WP 0148 00).
END OF WORK PACKAGE
0211 00-2
