TM 10-3930-675-24-2
FRONT GEAR COVER REPLACEMENT - CONTINUED
0212 00
REMOVAL - CONTINUED
4.
Remove six rectangular seals (12) at crankshaft seal mounting. Discard seals.
5.
Remove two rectangular seals (8 and 10) at accessory drive mounting and water pump mounting. Discard seals
6.
Remove O-ring (11) from hydraulic drive idler retainer. Discard O-ring.
7.
Remove front gear cover seal (9) from gear housing groove. Discard seal.
9
10
8
11
12
CLEANING
WARNING
Dry cleaning solvent P-D-680 type III is toxic and flammable. Wear protective goggles and gloves and
use only in a well-ventilated area. Avoid contact with skin, eyes, and clothes and do not breathe
vapors. DO NOT use near open flames or excessive heat. The solvent's flash point is 200F (94C). If
you become dizzy while using dry cleaning solvent, get fresh air immediately and get medical aid. If
solvent contacts eyes, wash your eyes and get medical aid immediately.
1.
Clean mating surface of front cover and gear housing with cleaning solvent and remove old gasket material.
2.
Clean seal grooves with cleaning solvent and remove all residue of old seals.
0212 00-3