TM 10-3930-675-24-2
TOPHANDLER WIRING HARNESSES REPLACEMENT - CONTINUED
0221 00
WIRING HARNESS D, JUNCTION BOX 182-TO-JUNCTION BOX 183: INSTALLATION - CONTINUED
9.
Install cover (4) on junction box 182 (6) and tighten four screws (5).
4
5
6
10.
Secure wiring harness D along cable routing by tightening clamps and installing new tiedown straps as needed.
11.
Perform operational check of tophandler (TM 10-3930-675-10).
WIRING HARNESS E, JUNCTION BOX 182-TO-JUNCTION BOX 184: REMOVAL
1.
Loosen four screws (5) and remove cover (4) from junction box 182 (6). Inspect rubber seal in groove of cover. Replace
only if damaged.
2.
Remove retainer nut (34), grommet (35), and sleeve (36).
NOTE
Use wiring diagrams in WP 0048 00, as needed, and note terminal block numbers to wire lead num-
bers for installation.
3.
Using jeweler's screwdriver, disconnect wiring harness E (37) leads from junction box 182 (6) terminal block (8).
Remove harness from junction box.
6
8
34,35,36
37
0221 00-14