TM 10-3930-675-24-2
TOPHANDLER WIRING HARNESSES REPLACEMENT - CONTINUED
0221 00
WIRING HARNESS E, JUNCTION BOX 182-TO-JUNCTION BOX 184: REMOVAL - CONTINUED
6.
Remove retainer nut (42), grommet (43), and sleeve (44).
NOTE
Use wiring diagrams in WP 0048 00, as needed, and note terminal block numbers to wire lead num-
bers for installation.
7.
Using jeweler's screwdriver, disconnect wiring harness E (37) leads from junction box 184 (40) terminal block (41).
Remove harness from junction box.
8.
Secure all loose leads of wiring harness E (37) to nonelectrical wire.
9.
With assistance, pull wiring harness E (37) out from conduit until approximately 18 in. (46 cm) of nonelectrical wire is
exposed.
10.
Remove wiring harness E (37) leads from nonelectrical wire and leave nonelectrical wire in place as a guide wire.
40
41
37
42,43,44
WIRING HARNESS E, JUNCTION BOX 182-TO-JUNCTION BOX 184: INSTALLATION
1.
At junction box 182 (6), secure all loose leads of wiring harness E (37) to nonelectrical wire.
2.
With assistance, pull wire harness E (37) through conduit until sufficient length is exposed to reach junction box 184
(40).
3.
Remove wiring harness E (37) from nonelectrical wire.
4.
Position retainer nut (42), grommet (43), and sleeve (44) on wiring harness E (37) at junction box 184 (40). Install har-
ness into junction box.
5.
Using jeweler's screwdriver, connect wiring harness E (37) leads to terminal block (41).
6.
Install sleeve (44), grommet (43), and retainer nut (42).
7.
Install cover (38) on junction box 184 (40) and tighten four screws (39).
0221 00-16
