TM 10-3930-675-24-2
BOOM LIFT CYLINDER REPLACEMENT - CONTINUED
0252 00
REMOVAL - CONTINUED
NOTE
Ensure sling is positioned so cylinder is balanced and will not tilt when removed from vehicle.
7.
Raise cylinder (3) until parallel with ground.
8.
At boom end of cylinder (3), remove nut (14), lockwasher (13), and washer (12). Discard lockwasher.
9.
Remove end of cylinder (3) from welded shaft (15) on boom.
10.
Lower cylinder (3) to ground.
14
13
12
15
3
350-395
INSTALLATION
WARNING
Boom lift cylinder weighs 885 lb (402 kg). Lifting device must have sufficient capacity to lift cylinder.
Failure to follow this warning may result in death or injury to personnel.
NOTE
Refer to General Maintenance Instructions in WP 0284 00 for complete instructions on connecting
hydraulic hoses and applying proper torque.
1.
Using nylon sling and lifting device, raise cylinder (3) parallel to ground and position on slide boom end of cylinder on
welded shaft (15).
2.
Slide end of cylinder (3) onto welded shaft (15).
3.
Install washer (12), new lockwasher (13), and nut (14). Bend tabs on lockwasher.
4.
Lower frame end of cylinder (3) to mounting bracket on vehicle body.
0252 00-4
