TM 5-3810-306-34
b. Ensure pin (19) is parallel with port face and
install drive (23) until fully seated against pin
(19).
c.
Install new packing (21) and gerotor (24) on
housing (16).
d. Install spacer(s) (25).
e. Install new packing (21) and end cap (26).
Secure with seven capscrews (27).
f.
Pre-tighten capscrews (27) to 150 in.-lbs (17
Nm) then torque screws to 275 in.-lbs (30 Nm) in
sequence shown.
5. INSTALL STEERING CONTROL VALVE. (REFER
TO PAGE 10-2.)
END OF TASK
10-8
