TM 5-3810-306-34
Section I. OUTRIGGER ASSEMBLY MAINTENANCE
OUTRIGGER BEAM INSTALLATION
TOOLS: General mechanic's tool kit: automotive (5180-00-177-7033)
Shop Equipment Auto-Maintenance and Repair Common No 1 (4910-00-754-0655)
Shop Equipment Auto-Maintenance and Repair; Org Suppl No 1 (4910-00-754-0653)
Lifting device (1 ton capacity)
SUPPLIES:
Cotter pins (Item 64, Appendix B)
Hydraulic oil (Item 8, Appendix B)
Loctite #545 (Item 18, Appendix B)
Preformed packing (Item 67, Appendix B) (2 Required)
Preformed packing (Item 68, Appendix B) (2 Required)
Grease (Item 9, Appendix B)
NEVER-SEEZ (Item 24, Appendix B)
EQUIPMENT CONDITION: None
REMOVAL:
NOTE
WARNING
Do not allow end of outrigger
extension cylinder to fall when
Outrigger beam assembly weighs
cylinder mounting shaft is removed.
approximately 1520 lbs (690 Kg). Use
Use an adequate blocking to support
care when removing outrigger beam
cylinder.
assembly.
a. Remove cotter pins (5) securing
cylinder
mounting shaft (4) and remove shaft.
1. EXTEND OUTRIGGER SLIGHTLY TO FACILITATE
ATTACHING A LIFTING DEVICE TO OUTRIGGER
6. REMOVE OUTRIGGER BEAM (6).
BEAM.
a. Attach a suitable lifting device to outrigger beam.
2. DISCONNECT NEGATIVE BATTERY CABLE AT
SHUNT. (REFER TO TM 5-3810-306-20.)
b. Pull outrigger beam out of outrigger box,
readjusting lifting attachment to maintain equal
3. REMOVE OUTRIGGER HOUSING COVER (1).
balance.
a. On opposite side of outrigger housing, remove
WARNING
two screws (2) securing cover (1) to housing.
Disconnect side marker light electrical connector
and remove cover.
Ensure any blocking material used is
capable of supporting weight of
4. TAG AND DISCONNECT THREE HYDRAULIC
outrigger beam. Do not allow it to tilt
LINES (3) AT CYLINDER END OF EXTENSION
or slide.
CYLINDER. CAP ALL LINES AND FITTINGS.
5. REMOVE EXTENSION CYLINDER MOUNTING
SHAFT (4).
11-2
