TM 9-3950-253-13&P
0007
PLACE LIFT FRAME ON GROUND
1.
Verify these conditions exist:
a.
Lift mechanism deployed (PLS: TM 9-2320-364-14&P, HEMTT: TM 9-2320-326-14&P).
b.
Lift frame on hook (Unload Empty Lift Frame).
c.
Stowage toggle switch set to OFF position (WP 0004).
d.
NO TRANS light off (PLS: TM 9-2320-364-14&P, HEMTT: TM 9-2320-326-14&P).
WARNING
These instructions require adjustments to the lift frame. Be aware that the frame
may swing on hook, especially in high winds.
During these adjustments, personnel must work outside the vehicle where there
are several projecting parts, and personnel are required to bend down. Take care
when bending and straightening. A hard hat is required.
Lift frame must be firmly positioned on solid, level ground.
Failure to follow these warnings may result in injury or death to personnel and
damage to equipment. Seek medical attention in the event of an injury.
NOTE
Perform steps 2 and 3 for right and left stands.
2.
With stand (Figure 14, Item 1) in upright position on lift frame (Figure 14, Item 2), remove locking pin
(Figure 14, Item 3) from stand.
3.
Rotate stand (Figure 14, Item 1) down until hole in stand aligns with hole in lower bracket (Figure 14, Item 4)
and insert locking pin (Figure 14, Item 3).
0007-10
03/15/2011Rel(1.10)root(opusualwp)wpno(O582007)