TM 9-3950-253-13&P
0069
REMOVAL
WARNING
During these procedures, personnel are required to work outside the vehicle where there
are several projecting parts, and personnel are required to bend down. Take care when
bending and straightening. A hard hat is required. Failure to follow this warning may result
in injury to personnel. Seek medical attention in the event of an injury.
NOTE
Perform steps 1 through 6 for both right and left sides.
Note position of collars on lifting pin to aid in installation.
1.
Raise air transport lifting pin (Figure 1, Item 7) until collar (Figure 1, Item 2) and spring pin (Figure 1, Item 3)
are accessible through cutout (Figure 1, Item 9).
2.
Remove spring pin (Figure 1, Item 3) and collar (Figure 1, Item 2) from air transport lifting pin (Figure 1,
Item 7). Discard spring pin.
3.
Remove air transport lifting pin (Figure 1, Item 7) from stowage assembly (Figure 1, Item 1).
4.
Remove spring pin (Figure 1, Item 4) and collar (Figure 1, Item 8) from air transport lifting pin (Figure 1,
Item 7). Discard spring pin.
5.
Remove two knobs (Figure 1, Item 5) from handle (Figure 1, Item 6).
6.
Remove handle (Figure 1, Item 6) from air transport lifting pin (Figure 1, Item 7).
0069-2
03/15/2011Rel(1.10)root(maintwp)wpno(M582068)