TM 9-3950-253-13&P
0068
REMOVAL - Continued
4.
Remove locknut (Figure 2, Item 3), washer (Figure 2, Item 4), and pin (Figure 2, Item 2) from stowage
assembly (Figure 2, Item 1). Discard locknut.
Figure 2. Pin Removal.
END OF TASK
CLEANING AND INSPECTION
Clean and inspect all parts IAW (WP 0061), General Maintenance Instructions.
END OF TASK
INSTALLATION
WARNING
During these procedures, personnel are required to work outside the vehicle where there
are several projecting parts, and personnel are required to bend down. Take care when
bending and straightening. A hard hat is required. Failure to follow this warning may result
in injury to personnel. Seek medical attention in the event of an injury.
1.
Install pin (Figure 2, Item 2), washer (Figure 2, Item 4), and new locknut (Figure 2, Item 3) on stowage
assembly (Figure 2, Item 1).
03/15/2011Rel(1.10)root(maintwp)wpno(M582067)
