TM 9-3950-253-13&P
0078
REMOVAL
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure any lifting device used is in good condition and of
suitable load capacity. Keep clear of heavy parts supported only by lifting device. Failure to
follow this warning may result in injury or death to personnel. Seek medical attention in the
event of an injury.
NOTE
Front slider bed weighs 137 lb (62 kg).
Perform steps 1 through 6 for both right and left sides.
1.
Attach sling and lifting device to front slider bed (Figure 1, Item 1).
2.
Use lifting device to remove slack from sling.
3.
Remove locknut (Figure 1, Item 5) and bolt (Figure 1, Item 6) from rear slider bed (Figure 1, Item 7). Discard
locknut.
WARNING
Use caution when removing pin. Components may fall when pin is removed. Support
components during removal of pin. Failure to follow this warning may result in injury to
personnel or damage to equipment. Seek medical attention in the event of an injury.
NOTE
Note number and location of shims to aid in installation.
4.
Remove pin (Figure 1, Item 4), shims (Figure 1, Item 2) and spacer (Figure 1, Item 3) from front slider bed
(Figure 1, Item 1).
5.
Use lifting device to remove front slider bed (Figure 1, Item 1) from rear slider bed (Figure 1, Item 7) and
place on flat work surface.
6.
Remove lifting device and sling from front slider bed (Figure 1, Item 1).
0078-2
03/15/2011Rel(1.10)root(maintwp)wpno(M582077)