TM 9-3950-253-13&P
0078
FOLLOW-ON MAINTENANCE - Continued
Figure 3. Slider Guide Measurement.
4.
Measure and record the distance between left rear slider guide (Figure 3, Item A) and right rear slider guide
(Figure 3, Item B).
NOTE
Add or remove shims equally on both right and left slider beds.
Shims are 0.04 in. (1 mm) thick. Divide the difference between measured value
and chart value by two to determine number of shims required per side.
Sum of A-B and C-D dimensions must equal 191.26 in. +/- 0.08 in. (4,858 mm +/-
2 mm).
5.
Locate recorded A-B dimension in Table 1. Compare recorded C-D dimension to corresponding C-D
dimension in Table 1.
6.
If recorded C-D dimension is less than required value, remove shims from outboard side of front slider bed
and add shims to inboard side of front slider bed.
7.
If recorded C-D dimension is greater than required value, remove shims from inboard side of front slider bed
and add shims to outboard side of front slider bed.
03/15/2011Rel(1.10)root(maintwp)wpno(M582077)