TM 9-3950-253-13&P
0079
REMOVAL
WARNING
Use caution and wear eye protection when removing clamping device. Clamping device is
spring loaded and may move erratically during removal. Failure to follow this warning may
result in injury to personnel or damage to equipment. Seek medical attention in the event of
an injury.
NOTE
Perform steps 1 through 8 for both right and left sides.
Mark position of holes in end of shaft to aid in installation.
1.
Remove and discard tiedown straps (Figure 1, Item 1) as required.
2.
Remove two bolts (Figure 1, Item 5) and washers (Figure 1, Item 4) from shaft (Figure 1, Item 3).
3.
Place punch in open hole to prevent shaft movement.
4.
While supporting clamping device handle (Figure 1, Item 2), remove bolt (Figure 1, Item 5), washer
(Figure 1, Item 4), and punch from shaft (Figure 1, Item 3).
0079-2
03/15/2011Rel(1.10)root(maintwp)wpno(M582078)