TM 9-3950-253-13&P
0078
INSTALLATION
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure any lifting device used is in good condition and of
suitable load capacity. Keep clear of heavy parts supported only by lifting device. Do not
allow fingers to come between front slider bed and roller assembly during installation.
Failure to follow this warning may result in injury or death to personnel. Seek medical
attention in the event of an injury.
NOTE
Front slider bed weighs 137 lb (62 kg).
Perform steps 1 through 5 for both right and left sides.
1.
Attach sling and lifting device to front slider bed (Figure 2, Item 1).
WARNING
Components may fall during installation of pin. If necessary, support components during
installation. Failure to follow this warning may result in injury to personnel or damage to
equipment. Seek medical attention in the event of an injury.
2.
Use lifting device to install front slider bed (Figure 2, Item 1) on rear slider bed (Figure 2, Item 7).
3.
Apply GAA to pin (Figure 2, Item 4).
NOTE
Install shims as noted during removal.
4.
Install spacer (Figure 2, Item 3), shims (Figure 2, Item 2), and pin (Figure 2, Item 4) in front slider bed
(Figure 2, Item 1).
5.
Install bolt (Figure 2, Item 6) and new locknut (Figure 2, Item 5) in rear slider bed (Figure 2, Item 7).
0078-4
03/15/2011Rel(1.10)root(maintwp)wpno(M582077)