TM 9-3950-253-13&P
0088
INSTALLATION
WARNING
Component will fall when attaching hardware is removed. Support component while
installing attaching hardware. Failure to follow this warning may result in injury to
personnel. Seek medical attention in the event of an injury.
NOTE
Perform steps 1 through 3 for both right and left sides.
1.
Install stand (Figure 1, Item 1), washer (Figure 1, Item 6), bolt (Figure 1, Item 7), washer (Figure 1, Item 5),
and new locknut (Figure 1, Item 4) on lift frame (Figure 1, Item 2). Verify that stand tilts after tightening bolt.
2.
Place stand in upright position and install locking pin (Figure 1, Item 9) with attached chain (Figure 1, Item 8)
in lift frame (Figure 1, Item 2).
3.
Install chain (Figure 1, Item 8), washer (Figure 1, Item 11), bolt (Figure 1, Item 10), and new locknut
(Figure 1, Item 3) on stand (Figure 1, Item 1).
END OF TASK
END OF WORK PACKAGE
0088-3/blank
03/15/2011Rel(1.10)root(maintwp)wpno(M582087)