TM 9-3950-253-13&P
FIELD MAINTENANCE
STOWAGE GUIDE POSITION CALIBRATION
INITIAL SETUP:
Tools and Special Tools
Equipment Condition (cont.)
Tool Kit, General Mechanic s (WP 0118, Table 2,
Lift frame placed on level ground (WP 0007)
Item 2)
Stowage control panel toggle switch set to OFF
Tool Set, SATS Base (WP 0118, Table 2, Item 3)
position (WP 0004)
Personnel Required
(Two)
References
Equipment Condition
Vehicle parked on level ground, in neutral gear
with parking brake applied
(PLS: TM 9-2320-364-14&P, HEMTT: TM
9-2320-326-14&P)
INTRODUCTION
This procedure calibrates the stopping positions of the stowage guide for stowing and unstowing the lift frame
during AUTO mode operation. The third (fully extended) position is calibrated first, followed by the second
position, then the first position.
END OF TASK
0089-1
03/15/2011Rel(1.10)root(maintwp)wpno(M582088)