TM 10-3930-641-34-1
CYLINDER LINER SPECIFICATIONS
(Sheet 1 of 1)
For installation:
a. Put liquid soap on grooves and seals on lower part of liner.
b. Put a 9L5854 Filler Band completely in SAE30 oil for a moment.
c. Install the band (3) around the groove under the liner flange.
d. Install the liner in the cylinder block immediately, before
expansion of the band.
(1)
Bore in liner
(new)..................................... 5.401 .001 in. (137.19 + 0.03 mm)
Maximum permissible bore when measured near upper end of the
wear surface of the cylinder
liner (worn)................................................ 5.408 in. (137.36 mm)
"Use again" maximum bore (when measured near upper end of the
wear surface of the
cylinder liner) ............................................ 5.405 in. (137.29 mm)
(2)
Thickness of flange
on liner.............................. .3500 + .0008 in. (8.890 + 0.020 mm)
(3)
Filler band.
2-87
