TM 10-3930-641-34-1
CRANKSHAFT SPECIFICATIONS
(Sheet 1 of 2)
(1)
Length of pin out of crankshaft
face...................................................... 25 .02 in. (6.4 0.5 mm)
(2)
Thrust plates, at center main bearing.
(3)
End play for the crankshaft
(new)....................................... 006 to .020 in. (0.15 to 0.50 mm)
(4)
Torque for five plugs...........................17 + 3 lb. ft. (23 + 4 N.m)
"Stake" (make a mark with a punch) the crankshaft to hold the plug
tight.
(5)
Length of dowel out of the
crankshaft.......................................... 16 + .02 in. (4.1 0.5 mm)
(6)
Maximum permissible temperatur e of the gear for
installation on the crankshaft ....................................400F (2040C)
(7)
Distance from the rear face of the crankshaft to the rear side of
the sleeve .......................................... 18 + .02 in. (4.6 0.5 mm)
(8)
Rear wear sleeve. Install as follows:
a. Clean the inner surface of the sleeve and the outer surface of the
crankshaft with quick cure primer.
b. Put 9S3265 Retaining Compound on the cleaned surfaces.
c. Install the sleeve on the crankshaft, with the chamfer on the
TA098821
outside.
Go on to Sheet 2
(9)
Distance from the front face of the crankshaft to the front side of
the sleeve ............................................. 0 to .03 in. (0 to 0.8 mm)
(10)
Front wear sleeve. Install as follows:
a. Clean the inner surface of the sleeve and the outer surface of the
crankshaft with quick cure primer.
'
2-91