TM 10-3930-641-34-1
SEQUENCE AND PRESSURE CONTROL VALVE SPECIFICATIONS
(Sheet 1 of 1)
Torque for bolt that holds the torque converter control
Test force ....................................................... 25.4 i 2.0 lb (113 i 9 N)
cable in the cover ..............................................................22 i 3 lb ft (28 t 4 N-m)
Free length after test ............................................ 4.86 in (123.4 mm)
(1)
2P5751 Spring (outer with yellow stripe):
Outside diameter ................................................... 562 in (14.27 mm)
Free length after test ................................. 3.53 + .19 in (89.7 + 4.8 mm)
(5)
8S6214 Spacers:
Outside diameter ........................................................ 580 in (14.73 mm)
Thickness of one spacer ......................................... 016 in (0.41 mm)
Test of spring:
Outside diameter of spacer ................................... 906 in (23.01 mm)
1. Put spring in compression
One spacer will change pressure
under a force of ....................................................... 3.25 lb (14.5 N)
approximately ............................................................... 4 psi (25 kPa)
2. Increase the force until the length of the spring
(5)
8S6215 Spacers:
decreases an additional .................................. 1.400 in (35.56 mm)
Thickness of one spacer ........................................ 0.36 in (0.91 mm)
3. At this time, the force on the spring
Outside diameter of spacer ................................... 906 in (23.01 mm)
must be13.00 i .59 lb .......................................................................(57.9 2.6 N)
One spacer will change pressure
(2)
6P5405 Spring (inner):
approximately ............................................................... 8 psi (55 kPa)
Free length after test ................................................... 3.25 in (82.6 mm)
Outside diameter ........................................................ 422 in (10.72 mm)
Test of spring:
1. Put spring in compression
under a force of ......................................................... 1.75 lb (7.8 N)
2. Increase the force until the length of the spring
decreases an additional .................................. 1.000 in (25.40 mm)
3. At this time, the force on the spring
must be ................................................... 6.50 i .24 lb (28.9 t 1.1 N)
(3)
4M1751 Spacers:
Thickness of one spacer .............................................. 016 in (0.41 mm)
Outside diameter of spacer ........................................ 594 in (15.09 mm)
One spacer will change
pressure .................................................................... 1.46 psi (10.1 kPa)
(3)
5S7001 Spacers:
Thickness of one spacer .............................................. 036 in (0.91 mm)
Outside diameter of spacer ................... 557 i .002 in (14.15 0.05 mm)
One spacer will change
pressure .................................................................... 3.27 psi (22.6 kPa)
(4)
2P5755 Spring for sequence valve:
Length under test force .......................................... 3.42 in (86.9 mm)
TA098872
2-142