TM 10-3930-641-34-1
FUEL INJECTION PUMP HOUSING REMOVAL/INSTALLATION (CONT)
(Sheet 5 of 11)
LOCATION/ITEM
ACTION
REMARKS
18. Camshaft (17)
Remove from pump housing.
19. Upper and lower pinion gear
Remove.
bearings (43)
20. Dowel (45) and idler gear shaft (44)
Remove from pump housing using dowel
puller.
Remove.
Remove with drive plate.
Remove with bearing puller.
(51)
ASSEMBLY
1. New fuel rack bearing (48) for right
Install as follows:
fuel rack
a. Aline dowels of fixture assembly with left
fuel rack bore.
b. Fasten fixture assembly to pump housing
with capscrew.
c. Place new bearing in position between the
fixture assembly and the fuel rack bore.
Tab of bearing must be up.
d. Aline the driver with the bearing. Push
driver until shoulder of driver makes
contact with fixture.
Go on to Sheet 6
3-51