TM 10-3930-641-34-1
FUEL INJECTION PUMP HOUSING DISASSEMBLY/ASSEMBLY (CONT)
(Sheet 9 of 11)
LOCATION/ITEM
ACTION
REMARKS
17. Link (7)
Install.
18. Bracket (5)
Install without, letting bracket turn
19. Timing pin, 5P9697, and spacer (13)
Install in pump housing to hold fuel racks at
zero (center) position.
20. Injection pumps bushings (15) and
Install with extractor and wrench as follows:
performed packing (14)
a. As each pump is installed, turn camshaft
until the lobe for that pump is at its lowest
point.
b. Put the space in gear segment in alignment
with the groove in pump barrel. Put the in-
jection pump straight down into the hous-
ing bore with the space in gear segment
engaged with the pin in the lifter and the
groove in barrel engaged with the dowel in
the pump housing.
c. Install bushing (15) in the pump housing
bore. If the injection pump is in the correct
position, bushing will screw into the threads
of the pump housing with the fingers until
it is even with the housing.
d. Tighten bushings (15) to a torque of 140
to 160 lb. ft. (203.4 + 13.5 N-m) with
injection pump wrench. Install the felt
washer for each injection pump.
e. Check the fuel rack movement after each
pump is installed.
NOTE
Rack must move at least 0.8 in. (2.0 cm) from
centered position after pumps are installed.
Go on to Sheet 10
3-55
