TM 10-3930-641-34-1
FUEL INJECTION PUMP HOUSING DISASSEMBLY/ASSEMBLY (CONT)
(Sheet 7 of 11)
LOCATION/ITEM
ACTION
REMARKS
6. Inside bearing (54)
Install from inside pump housing.
NOTE
The distance (A) between bearings must be
1.37 in. (34.798 mm).
7. Lip seal
Install with inside bearing (54).
NOTE
Lip of seal must be away from bearing (54).
Seal must be even with inner housing surface.
8. Lower bearing (43) of pinion gear
Install with bearing driver.
NOTE
Chamfer must be toward inside. Install bearing
until face is even with lower surface of bearing
bore.
9. Upper bearing (43) of pinion gear
Install with bearing driver.
NOTE
Chamfer must be toward inside. Notch of
bearing must be as shown. Install bearing until
face is even with upper surface of bearing bore.
10. Camshaft (17)
Install.
TA099003
Go on to sheet 8
3-53
