TM 10-3930-675-20-2
0066 00-3
THERMOSTAT REPLACEMENT - CONTINUED
0066 00
INSTALLATION
NOTE
Ensure sealing surfaces of thermostat housing and housing support are clean and free of all material.
1.
Install thermostat (8) and new seal (9) in thermostat housing (3).
2.
Position thermostat housing (3) on housing support (6) and secure with four screws (7). Tighten screws to 40 lb-ft (54
Nm).
3.
Connect upper hose (2) and lower hose (4) to thermostat housing (3) and secure with hose clamps (1). Ensure that flow
restriction disc (5) is installed.
NOTE
Ensure radiator draincock is closed.
4.
Replace coolant in system. Start engine (TM 10-3930-675-10) and check for leaks.
5.
Top off coolant level as needed (WP 0063 00).
6.
Install radiator splash shield (WP 0136 00).
7.
Install alternator (WP 0069 00).
END OF WORK PACKAGE
1
2
3
1
4
5
