TM 10-3930-675-24-1
ENGINE FUEL INJECTOR CIRCUITS TROUBLESHOOTING - CONTINUED
0008 00
Table 7. Error Code 1322 - Injector Circuit Failure Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1322 - Injector Circuit Failure -
b. Check actuator harness and
Remove dirt and moisture from
Continued.
ECU connector for dirt or
connector. Replace missing or
damaged connector seals (WP
moisture in or on connector
0113 00).
and for missing or damaged
connector seals.
2. Place ignition switch in OFF
position
and
disconnect
actuator harness from engine
ECU and 15-pin connector at
front of engine below rocker
arm cover. Install jumper wire
from pin 1 to pin 2 at 15-pin
connector, actuator harness
side.
3. Measure resistance from a. If resistance is not as specified,
actuator harness connector pin
repair or replace connectors
(WP 0113 00).
9 to actuator harness connector
pin 10. Resistance should be b. If engine harness requires
replacement, notify SRA.
less than 10 Ohms.
<10 OHMS
0008 00-23
