TM 10-3930-675-24-1
ENGINE FUEL INJECTOR CIRCUITS TROUBLESHOOTING - CONTINUED
0008 00
Table 7. Error Code 1322 - Injector Circuit Failure Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1322 - Injector Circuit Failure -
b. Measure resistance from 15- If resistance is not as specified,
Continued.
pin connector pin 2 (or B) to notify SRA to replace internal
each injector pigtail nut that actuator harness.
connects the no. 1 injector
(resistance to one of these
nuts must be within
specifications). Resistance
should be less than 10 Ohms.
<10 OHMS
8. Place ignition switch in OFF
position
and
disconnect
internal actuator harness from
injector solenoid connector
and
disconnect
injector
solenoid wires from solenoid.
a. Measure resistance from pin a. If resistance is as specified,
A (or 1) of injector solenoid
notify SRA to replace internal
connector to injector wire
actuator harness.
pigtail nut. Resistance b. If resistance is not as specified,
should be less than 10 Ohms.
replace injector solenoid
wires.
b. Measure resistance from pin a. If resistance is as specified,
B (or 2) of injector solenoid
notify SRA to replace internal
connector to injector wire
actuator harness.
pigtail nut. Resistance b. If resistance is not as specified,
should be less than 10 Ohms.
replace injector solenoid
wires.
0008 00-27
