TM 10-3930-675-24-1
ENGINE FUEL INJECTOR CIRCUITS TROUBLESHOOTING - CONTINUED
0008 00
Table 7. Error Code 1322 - Injector Circuit Failure Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1322 - Injector Circuit Failure -
d. Measure resistance from a. If resistance is not as specified,
Continued.
actuator harness connector
repair or replace connectors
(WP 0113 00).
pin 10 to all pins in sensor
connector. b. If engine harness requires
harness
replacement, notify SRA.
Resistance should be greater
than 100k Ohms.
5. Place ignition switch in OFF
position
and
disconnect
actuator
harness
15-pin
connector at front of engine
below rocker arm cover.
Disconnect actuator harness
connector from engine ECU.
a. Measure resistance from a. If resistance is not as specified,
actuator harness connector
repair or replace connectors
(WP 0113 00).
pin 9 to engine block ground.
Resistance should be greater b. If engine harness requires
replacement, notify SRA.
than 100k Ohms.
b. Measure resistance from a. If resistance is not as specified,
actuator harness connector
repair or replace connectors
(WP 0113 00).
pin 10 to engine block
ground. Resistance should b. If engine harness requires
replacement, notify SRA.
be greater than 100k Ohms.
>100K OHMS
0008 00-25
