TM 10-3930-675-24-1
ENGINE FUEL INJECTOR CIRCUITS TROUBLESHOOTING - CONTINUED
0008 00
Table 7. Error Code 1322 - Injector Circuit Failure Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1322 - Injector Circuit Failure - 4. Place ignition switch in OFF
Continued.
position
and
disconnect
actuator harness from engine
ECU and 15-pin connector at
front of engine below rocker
arm cover. Disconnect sensor
harness from ECU engine.
a. Measure resistance from a. If resistance is not as specified,
actuator harness connector
repair or replace connectors
(WP 0113 00).
pin 9 to all pins in actuator
connector. b. If engine harness requires
harness
replacement, notify SRA.
Resistance should be greater
than 100k Ohms.
b. Measure resistance from a. If resistance is not as specified,
actuator harness connector
repair or replace connectors
(WP 0113 00).
pin 9 to all pins in sensor
connector. b. If engine harness requires
harness
replacement, notify SRA.
Resistance should be greater
than 100k Ohms.
c. Measure resistance from a. If resistance is not as specified,
actuator harness connector
repair or replace connectors
(WP 0113 00).
pin 10 to all pins in actuator
connector. b. If engine harness requires
harness
replacement, notify SRA.
Resistance should be greater
than 100k Ohms.
>100K OHMS
>100K OHMS
0008 00-24
